Page 1
CAL. V33J, VX3F ANALOGUE QUARTZ Time display: Hour, minute and second Time display: Month [VX3F only], date, and day of the week 24-hour display...
Page 2
DISPLAY AND CROWN/BUTTONS [V33J] [VX3F] Hour hand Hour hand Month hand Day hand Day hand Minute hand Minute hand CROWN CROWN a b c a b c Date hand Date hand Second hand Second hand 24-hour hand 24-hour rotating wheel...
SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
TIME/CALENDAR SETTING DAY AND TIME SETTING CROWN Second hand 1 Pull out to second click when Second hand is at the 12 o’clock position. ➠ 2 Turn clockwise to advance Hour and Minute hands until Day hand is set to the desired day of the week.
DATE SETTING CROWN ➠ 1 Pull out to first click. 2 Turn clockwise to set Date hand to the desired date. 3 Push in. Date hand MONTH SETTING (only for VX3F) Month hand CROWN 1 Pull out to first click. ➠...
NOTES ON OPERATING THE WATCH DAY AND TIME SETTING G To advance the day hand quickly, turn back the hour and minute hands 4 to 5 hours beyond the point the day normally changes, and then advance them again until the day hand is set to the next.
G When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. G We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement.
Page 8
WARNING G Do not remove the battery from the watch. G If it is necessary to take out the battery, keep it out of the reach of children. If a child swallows it, consult a doctor immediately. G Never short-circuit, tamper with or heat the battery, and never expose it to fire.
3 bar, such as acci- taking a bath, shallow diving, but not for scuba dental contact with splashes of water or rain, but it is diving. We recommend that you wear a PULSAR not designed for swimming or diving. Diver’s watch for scuba diving.
Page 10
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the crown is pushed in completely. Do not operate the crown when the watch is wet or in water. If used in sea water, rinse the watch in fresh water and dry it completely.
2 to 3 years. Have careful not to drop your your watch checked by an watch or hit it against hard AUTHORIZED PULSAR surfaces, as this may DEALER or SERVICE CENTER to cause damage. ensure that the case, crown, buttons, CHEMICALS gasket and crystal seal remain intact.
Need help?
Do you have a question about the V33J and is the answer not in the manual?
Questions and answers