Manual Ip Address Setup - Hitron E31N2V1 User Manual

1.5.1

Manual IP Address Setup

By default, your E31N2V1's local IP address is 192.168.100.1. If your E31N2V1 is
using the default IP address, you should set your computer's IP address to be
between 192.168.100.2 and 192.168.100.254.
Take the following steps to manually set up your computer's IP address to connect to
the E31N2V1:
NOTE: This example uses Windows 7; the procedure for your operating system may
be different.
1
Click the Start Orb, then click Control Panel.
2
In the window that displays, double-click Network And Sharing Center.
3
In the left-hand panel, click Change Adapter Settings.
4
Right-click your network connection (usually Local Area Connection) and click
Properties.
5
In the Networking tab's This connection uses the following items list, scroll
down and select Internet Protocol (TCP/IPv4). Click Properties.
6
You can get an IP address automatically, or specify one manually:
If your network has an active DHCP server, select Get an IP address

automatically.
If your network does not have an active DHCP server, select Use the

following IP address. In the IP address field, enter a value between
192.168.100.2 and 192.168.100.254 (default). In the Subnet mask field,
enter 255.255.255.0 (default). In the Default Gateway field, enter
192.168.100.1 (default).
NOTE: If your E31N2V1 is not using the default IP address, enter an IP address and
subnet mask that places your computer in the same subnet as the E31N2V1.
7
Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click Close.
Your computer now obtains an IP address from the E31N2V1, or uses the IP address
that you specified, and can communicate with the E31N2V1.
16 16
Version 1.0, 11/2017. Copyright
Version 1.0, 11/2017. Copyright
Hitron E31N2V1 User's Guide
2012 Hitron Technologies
2017 Hitron Technologies