Installation; Sliding Window Sealing Board Assembly Installation; Heat Exhaust Hose Installation - ProBreeze PB-AC05 Instruction Manual

Installation

Prior to and after installation adhere to
the below:
•
When moving the appliance to the
chosen location ensure it is kept in an
upright position.
•
Do not place or use the appliance,
power cord, or any accessories in a
bathroom, wet, or damp place.
•
Place the appliance on a flat and
dry surface. Keep it at least 50cm
away from surrounding walls and/or
objects.
• Leave the appliance in an upright
position for at least two hours prior
to first use.

Heat Exhaust Hose Installation

1. Insert the circular connector into the
heat exhaust hose connector.
2. Rotate the circular connector
counterclockwise to lock it into place.
Circular connector
08 | English
Sliding Window Sealing Board Assembly
Installation
1. Insert panel B into panel A and adjust
to the length or height of the window.
2. Open window and place the sealing
board assembly into window.
3. Adjust to ensure an exact fit and
secure with the provided screw.
4. Close window to lock everything into
place.
5. Attach the heat exhaust hose short
connector to the elliptical hole.
6. The sealing board assembly is now
ready for use.
Notes:
•
If your window opening is smaller
than the minimum length of the
sealing board assembly trim to
desired length using a hacksaw.
•
If your window opening is larger than
the maximum length of the sealing
board assembly use plywood or
similar to fill the gap.