Leica M10 Instructions Manual page 99

1. Bright-line frames for 50mm and 75mm
2. Metering field for distance setting
3. LEDs (Light Emitting Diodes) for:
1
a. Four-digit digital display with dots above and below
Digital display:
– Display of the automatically determined shutter speed
for aperture priority
speeds slower than 1s
– Warning that the metering or setting ranges are over-
shot or undershot using aperture priority
– Displays the exposure compensation value (briefly
during adjustment, or for about 0.5s when exposure
metering is activated by tapping the shutter button)
– Indicates that the back-up memory is (temporarily) full
– Indicates that no memory card is loaded (
– Indicates that the memory card is full (
b. • Dot above:
– Indicates (when lit) that saved metering values are being
used
c. • Dot below:
– Indicates (flashing) that exposure compensation is being
used
(example)
1
, or for counting down shutter
A
A
)
Sd Sd
)
Full Full
d. Two triangular and one circular LED:
– For manual exposure setting: Together as a light bal-
ance. The triangular LEDs indicate the direction of rota-
tion of the aperture setting ring and shutter speed dial
to adjust the exposure.
– Warning of values below the metering range
e. Flash symbol:
– Flash ready to use
– Details of flash exposure before and after the picture
With automatic brightness control adjusted to the ambient brightness. This
1
automatic control is not available for Leica M lenses with viewfinder attachments,
since they cover the brightness sensor
for their operation. In such cases the frame and displays always maintain a con-
stant brightness.
5 which supplies the information required
EN
211