Leica M10 Instructions Manual page 61

3. In the line, select the desired value, in the
Frames Frames
the desired exposure difference, and in the
line the exposure compensation value (optional).
• The marked exposure values change positions according to
the settings selected. In the case of exposure compensa-
tion, the scale also shifts.
4. In the line select whether the pictures should all be
Automatic Automatic
taken by pressing the shutter button once -
- .
Off Off
5. Confirm the setting by pressing the Center button.
6. All pictures are produced by pressing the shutter button once
or several times.
Notes:
line
F-Stops F-Stops
• The following rule applies when using automatic bracketing:
Exp. Compensation Exp. Compensation
with automatic control of the ISO sensitivity (see p. 156), the
sensitivity automatically determined by the camera for the
uncorrected pictures is also used for all other pictures in a
series, i.e. this ISO value is not changed during a series. This
may mean that the slowest shutter speed specified under
, or all individually
Maximum Exposure Time Maximum Exposure Time
On On
• Depending on the initial shutter speed, the working range for
automatic bracketing may be limited.
Regardless of this, the specified numbers of pictures are always
taken, which may mean that several pictures in a series have the
same exposure.
• Automatic bracketing is also possible when using flash. It is
implemented without regard to the state of charge of the flash
unit, meaning the series may contain shots both with and with-
out flash.
• The function remains active until another function is selected in
the
off and on again. If no other function is selected, another series
of pictures is taken each time the shutter button is pressed.
is exceeded.
sub-menu, i.e. even after switching the camera
Drive Mode Drive Mode
EN
173