Maintenance - Snapper XD 1696869 Owner's Manual

MAINTENANCE

W A R N I N G
When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product
damage.
W A R N I N G
Always wear safety goggles or safety glasses with side shields during product operation. If operation is dusty, also wear a
dust mask.
W A R N I N G
Before inspecting, cleaning, or servicing the machine, disconnect the battery from unit and wait for all moving parts to stop.
Failure to follow these instructions can result in serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
W A R N I N G
Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., Come in contact with plastic
parts. Chemicals can damage, weaken, or destroy plastic which may result in serious personal injury. Only the parts shown
on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an authorized
service center.
STORING THE CULTIVATOR
The following steps should be taken before storing the cultivator for the season.
• Clean dirt, grass, and other materials from the entire unit.
• Wipe the tines with oil or spray them with silicone lubricant to prevent rusting.
• Oil the switch trigger cable and all visible moving parts. Do not remove the motor cover.
• Order new parts to replace any that are badly worn or broken.
• Store in an upright position in a clean, dry place. Store with the handles in the extended position, or loosen handle knobs
and fold handles down. Do not allow switch trigger cable to become pinched when lowering the handlebar.
PREPARING FOR USE AFTER STORAGE
The following steps should be taken before using the cultivator after it has been stored.
• Unfold the handles into the upright position and secure by tightening handlebar knobs. Do not allow the switch trigger
cable to become pinched when raising the handlebar.
• Follow the steps to restart the cultivator.
17