Snapper XD 1696869 Owner's Manual page 10

ASSEMBLY
INSTALLING THE TINES (See Figure 4)
W A R N I N G
To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the tool when
assembling parts.
1. Remove the battery from the unit.
2. Lean the unit back on its wheels so that it is resting securely with the handlebar on the ground.
NOTE: This view of the gearbox is from the front of the cultivator.
TINE (D)
RING PIN
3. Place tine (C) on the tine shaft to the left of the gear box. The stamped side of the tine should face away from the gear
box.
4. Place tine (B) on the tine shaft to the right of the gear box. The stamped side of the tine should face away from the
gear box.
5. Place a felt on each side of the tine shaft, and slide to rest against the inner tine.
6. Place the outer tine stamped (D) on the left side of the tine shaft. The stamped side should face in toward tine (C).
7. Place the outer tine stamped (A) on the right side of the tine shaft.The stamped side should face in toward tine (B).
8. To secure the tines to the tine shaft, insert the ring pins into the holes located on either side of the tine shaft.
TINE (C)
FELT
GEAR BOX
TINE SHAFT
10
TINE (B) TINE (A)
FELT
RING PIN
Fig. 4