Table of Contents
Advertisement
Figure 3
Removing and Replacing the Chassis Cover Panel
Captive screws
Pull the top of the panel out about three inches, then grasp the sides of the panel and pull it
Step 3
up and away from the chassis.
To replace the cover panel, hold the sides of the panel with both hands and tilt the top of
Step 4
the panel back slightly (toward you).
Step 5
Slide the guide tabs into the slots in the bottom edge of the chassis. (See Figure 3.)
Step 6
Using the guides as a pivot point, push the top half of the panel back toward the chassis
opening until the panel is flush with the edges of the chassis.
Step 7
Hold the top front of the panel in place, if necessary, while you tighten the two captive
slotted screws with a 3/16-inch, flat-blade screwdriver.
The chassis cover panel removal and replacement procedure is now complete.
600W DC-Input Power Supply Replacement Instructions
Power Supply Replacement
7
Advertisement
Table of Contents
