2. Basic operations
A. Programming the control panel
After connecting the transformer
AQUAHOME 11-N should feature
Then, the display screen will show
to the power socket, the display
screen will show the code of the
given device model and test
number (J2.0 or similar) for 3
seconds.
the 11L code, while AQUAHOME
17-N should feature the 17L code
the PRESENT TIME caption and
the time 12:00 will start flashing in
the bottom left corner.
Setting Time
If the PRESENT TIME information was not
displayed, it is necessary to press the "OK"
button (fig. 4) until the information is
displayed. In order to set the time, press ▲ to
move forward or ▼ to go backwards.
If a twelve-hour clock is set, the "ante mridiem
(AM) caption will appear for the time between
00
0
and 11
appear for the time between 12
With each pressing of the
the time will increase or decrease in one
minute increments. If any of the buttons
remains pressed, the time will change at a
faster rate.
It is necessary to deactivate and
activate the power supply to
confirm the correctness of the
code. If the code displayed on the
screen is different than expected,
please contact the supplier's
service team.
Audio signaller (BIP): the signaller
will activate each time the button
is pressed. A single audio signal
indicates one change on the
display screen. Series of audio
signals indicate wrong button
being pushed and the need to
push a different button.
59
and the "post meridiem" (PM) will
00
▲ or ▼ buttongs,
Fig. 4
59
and 23
.
9