Table of Contents
Advertisement
9.1.4 Making cross cuts (Fig. 43)
•
Slide the cross stop (13) into one of the two
grooves (29) on the sawing table and adjust
to the desired angle (see 8.6). Should the saw
blade (5) additionally be set diagonally, use
the groove (29) which would not enable your
hand and the cross stop to come into contact
with the saw blade.
•
If necessary, use a stop rail (e).
•
Press the workpiece firmly against the cross
stop (13).
•
Switch on the saw.
•
Push the cross stop (13) and the workpiece
toward the blade in order to make the cut.
•
Important: Always hold the guided part of the
workpiece. Never hold the part which is to be
cut off.
•
Push the cross stop (13) forward until the
workpiece is cut all the way through.
•
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.
9.1.5 Cutting particle board panels
To avoid break-off at the cut edges when cutting
particle board, the saw blade (5) should not be set
higher than 5mm more than the workpiece thickness
(see also 8.2).
10. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its
after-sales service or similarly trained personnel to
avoid danger.
11. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
11.1 Cleaning
•
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the appliance with a clean cloth or blast
it with compressed air at low pressure.
•
We recommend that you clean the appliance
immediately after you use it.
•
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to
the plastic parts in the appliance. Ensure that
no water can get into the interior of the tool.
11.2 Carbon brushes
•
In case of excessive sparking, have the carbon
brushes checked by a qualified electrician.
Caution: The carbon brushes should not be
replaced by anyone but a qualified electrician.
After Sales Support
TEL: 1300 922 271
11.3 Ordering replacement parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
For further information please call us on 1300
922 271 or email service.australia@einhell.com
12. Disposal and recycling
The device is supplied in packaging to prevent
its being damaged in transit. This packaging is
raw material and can therefore be reused or
can be returned to the raw material system. The
appliance and its accessories are made of
various types of material, such as metal and
plastic. Defective components must be
disposed of as special waste.
TAURUS
®
is a registered trademark of ALDI Stores.
ALDI Guarantee
Specially made for ALDI Stores to our stringent
quality specifications. If you are not entirely
satisfied with this product, please return it to your
nearest ALDI store within 60 days from the date of
purchase for a full refund or replacement, or take
advantage of our after sales support by calling the
supplier's Customer Service Hotline.
EMAIL: service.australia@einhell.com
22
m
06/2011
Hide quick links:
Advertisement
Table of Contents
