Subscribe to Our Youtube Channel
Related Manuals for Taurus bt-mc 355
Summary of Contents for Taurus bt-mc 355
- Page 1 2100W METAL CUT OFF SAW INSTRUCTION MANUAL MODEL NUMBER BT-MC 355 AFTER SALES SUPPORT TEL: 1300 922 271 EMAIL: service.australia@einhell.com N26704...
-
Page 2: Table Of Contents
Congratulations on choosing to buy a TAURUS® product. All products brought to you by TAURUS® are manufactured to the highest standards of performance and safety, and, as part of our philosophy of customer service and satisfaction, are backed by our comprehensive Year Warranty. - Page 3 b 10 After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
- Page 4 After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
-
Page 5: General Safety Rules
1. GENERAL SAFETY RULES d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to rotating part of the power tool may WARNING! Read all instructions Failure to result in personal injury. follow all instructions listed below may result e. -
Page 6: Special Saftey Rules
2. SPECIAL SAFETY RULES 13. Keep your electric tools in a safe place. When equipment is not being used it should be kept in a dry, closed place out of children’s reach. 1. For your own safety, read these safety instructions before you put the electric tool into operation. -
Page 7: Layout
34. Allow the motor to reach top speed before you begin to Wear ear-muffs. cut. The impact of noise can cause 35. After you have switched on, lower the cut-off wheel slowly damage to hearing. until it comes into contact with the workpiece. Then carry Wear a breathing mask. -
Page 8: Items Supplied
4. ITEMS SUPPLIED 6. TECHNICAL DATA AC motor 240 V ~ 50 Hz • Metal cut-off saw Power P 2100 W • 2x Cut-off wheel Idle speed 3800 min • Open-ended wrench Cut-off wheel Ø 355 x Ø 25.4 x 3.2 mm •... -
Page 9: Assembly
• Release the (fig.2/Item 13) locking device. adjusted with the stop screw (18). This is necessary to compensate wheel wear—as the cut-off 8. ASSEMBLY wheel becomes smaller in diameter it would no longer be able to cut right through the workpiece. Important. -
Page 10: Maintenance
phase, the appliance can be switched back on by pressing the overload switch (14) 9.3 Making a cut (Fig. 9) • Clamp the workpiece securely in the vice (15). • Switch on the machine and wait for the motor to reach its top speed. - Page 11 After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
- Page 12 08/2012 45.031.29_11012(01) After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com...
Need help?
Do you have a question about the bt-mc 355 and is the answer not in the manual?
Questions and answers