Before You Start; Package Check List; Special Parts Check List - Northern Telecom Flash Voice Mail Light 2 Installation Manual

2

Before you start

Read this guide.
Make sure all the equipment in the package is accounted for. A Package
check list is provided later in this guide.
Make sure you have the necessary tools to complete the installation. A
Special parts check list is provided later in this guide.
Make sure the environment and electrical conditions are met. An
Environment and an Electrical check list are provided later in this
guide.
Make sure you are familiar with the steps required to install Flash. An
Installation check list is provided later in this guide.

Package check list

Make sure the package contains:
a Flash module
a power supply
a teladapt cord (two cords are required for a Model 4)
shrink wrapped packages of documentation
a Feature Cartridge

Special parts check list

To begin an installation, you need:
screwdriver or power drill
anti-static grounding strap
two #10 X 2.5 cm (#10 X 1 in) round head wood screws
one modular telephone jack (two jacks are required for a Model 4)
twisted pair station wire
plywood backboard 2 cm (3/4 in) thick
surge protector (recommended)
RS-232 terminal or RS-232 printer with cable (optional)
Norstar Installation Guide
Note: If there are no free station ports at the distribution block you need
this guide for instructions on installing a Norstar station port.
This equipment is not supplied with the Flash module.
Flash Installation Guide P0908433 01