Table of Contents
Advertisement
6
Figure 3 Installation overview
Flash Module
Connecting the module to the KSU
Before you begin, ensure a Norstar station port is available at the distribution
block and all line appearances are removed from the Flash DN(s) prior to
booting the unit. For instructions on installing a station port and removing
line appearances, refer to the Norstar Installation Guide that came with the
Norstar KSU.
To connect the module:
1. Locate the distribution block.
2. Ensure there are available station ports at the distribution block. You
need one station port for a two channel Flash and two station ports for
a four channel Flash.
3.
Mount the teladapt jack(s) next to the distribution block.
4.
Use twisted pair station wire to connect each teladapt jack to a free
station port in the distribution block.
5.
Use a working Norstar telephone to test the port(s).
Flash Installation Guide
Feature
Cartridge
Power Supply
Norstar Modular KSU
Distribution Block
P0908433 01
Advertisement
Table of Contents
Need help?
Do you have a question about the Flash Voice Mail Light 2 and is the answer not in the manual?
Questions and answers