Toro Z Master Professional 5000 Series Operator's Manual page 63

12. To adjust the single point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 94).
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If
the deck is too high, loosen the single point
adjustment bolt by rotating it counterclockwise
(Figure 95).
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
the length of the available travel in their slots.
This will regain some up and down adjustment
on each of the 4 deck links.
1. Single-point adjustment bolt
14. Tighten the 2 bolts at the bottom of the
height-of-cut plate
Figure 94
Figure 95
(Figure 94). T
Note:
In most conditions, the back blade tip
should be adjusted 6.4 mm (1/4 inch) higher
than the front.
15. Torque the 2 bolts to 37 to 45 N∙m (27 to 33 ft-lb).
16. On both sides of the deck, measure from the
level surface to the back tip of the blade (postion
B) as shown in
Note:
The measurement should read 8.3 cm
(3-1/4 inches)
17. Fine tune the screw adjuster by turning it to get
8.3 mm (3-1/4 inches) height
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
18. Measure until all 4 sides are the correct height.
19. Tighten all of the nuts on the deck-lift-arm
assemblies.
20. Lower the discharge chute.
g027345
g017036
63
Figure 92.
(Figure 93).