Toro Z Master Professional 5000 Series Operator's Manual page 46

Figure 58
Installing the Battery
Note:
Position battery in the tray with the terminal
posts opposite from the hydraulic tank
Figure 59
Charging the Battery
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1.
g027728
2.
3.
(Figure 59).
g032526
1. Positive battery post
2. Negative battery post
46
WARNING
Always keep the battery fully charged
Charge battery for 10 to 15 minutes at 25 to 30
A or for 30 minutes at 10 A.
When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 60).
Install the battery in the machine and connect
the battery cables; refer to
(page 46).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 60
Installing the Battery
g000960
3. Red (+) charger lead
4. Black (-) charger lead