Toro Z Master Professional 5000 Series Operator's Manual page 62

Figure 91
1. Deck-lift pedal
2. Height-of-cut pin
6. Insert the height adjustment pin into the 76 mm
(3 inches) cutting height location.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the
level surface to the front tip of the blade (Postion
A) as shown in Figure
Note:
The measurement should read 76 mm
(3 inches)
g027343
3. Transport lock
92.
1. 76 mm (3 inches) at
position A is correct
2. 83 mm (3-1/4 inches) at
position B is correct
10. If needed, loosen the whizlock nut on the side of
the yoke and the jam nut on top
11. Fine tune the screw adjuster by turning it to get
76 mm (3 inches) height.
Note:
To increase the height, turn the
adjuster screw clockwise; to decrease, turn it
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height , the
single point adjustment can be utilized to gain
more adjustment.
1. Whizlock nut
2. Adjuster screw
62
Figure 92
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
Figure 93
3. Jam nut
4. Yoke
g009196
93).
g010251