U-Line 75F Use And Care Manual page 9

Condenser Cleaning
Interval - Every Three Months
To maintain operational efficiency, keep the front grille
free of dust and lint, and clean the condenser every three
months. Depending on environmental conditions, more
or less frequent cleaning may be necessary.
WARNING
Disconnect electric power to the unit before
cleaning the condenser.
WARNING
DO NOT touch the condenser fins. The condenser
fins are SHARP and can be easily damaged.
IMPORTANT IMPORTANT
DO NOT use any type of cleaner on the condenser
unit.
1. Disconnect power to the unit.
Figure 5
2. Remove the control knob (Figure 5, 1) by pulling it
straight out, away from grille.
3. Remove screw from grille (Figure 5, 2) and save.
4. Remove the grille.
1
Figure 6
5. Clean the condenser coil (Figure 6, 1) using a using a
soft brush with a "combing" action or vacuum cleaner.
Do not touch the condenser coil.
ULIN_0228_A
ULIN_0153_A
75F
Figure 7
6. Place the two hook-hinges (Figure 7, 1) located on the
rear bottom side of the grille onto the front lip of the
unit base. Swing the grille up into position, and align
the screw hole on the grille to the grille screw hole on
the cabinet.
7. Insert the screw (Figure 5, 2). Do not overtighten.
8. Reinstall the control knob (Figure 5, 1).
9. Reconnect power to the unit.
Leveling
It is important that units equipped with adjustable feet
are level, for proper door and ice maker (if equipped)
operation.
To level units with adjustable feet:
1
Figure 8
1. Use a level to check the levelness of the unit from
front to back and from side to side. Level should be
placed along top edge and side edge as shown
(Figure 8).
Figure 9
1
2
ULIN_0154_A
ULIN_0041_A
1
ULIN_0042_A
9