U-Line 75F Use And Care Manual page 11

5. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 13). Do not
install hinge on cabinet at this time.
Figure 14
6. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet (Figure 14).
7. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge (Figure 13).
Figure 15
8. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit (Figure 15).
Partially tighten screws.
1
Figure 16
9. Relocate plastic spacer/bushing (Figure 16) on bottom
of door to the opposite side. Clean out bushing hole in
door bottom if necessary.
ULIN_0107_A
ULIN_0108_A
ULIN_0109_A
75F
Figure 17
10. Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws) (Figure 17). Partially tighten
screws.
11. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
12. Replace four plastic plugs removed in Step 3 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
13. Reinstall grille to unit.
ULIN_0110_A
11