Door Reversal - U-Line 75F Use And Care Manual

2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (Figure 9).
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
Door Alignment Check and Adjustment
IMPORTANT IMPORTANT
Properly aligned, the door's gasket should be firmly
in contact with the cabinet all the way around the
door (no gaps). Carefully examine the door's gasket
to assure that it is firmly in contact with the
cabinet. Also make sure the door gasket is not
pinched on the hinge side of the door.
Figure 10
NOTE: It may be necessary to remove the grille to access
lower hinge screws.
1. Loosen (do not remove) top (Figure 10) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.
10
ULIN_0104_A
75F

Door Reversal

To reverse the door, perform the following:
Figure 11
1. Remove grille unit.
2. Remove top hinge from cabinet (four screws) (Figure
11). Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
Figure 12
4. Remove four plastic plugs (Figure 12) in hinge holes,
top of cabinet, opposite side. Be careful not to scratch
cabinet.
Plastic
Plug Hole
Right Side
Door Swing
Right Side
Hinge
Figure 13
ULIN_0104_A
ULIN_0105_A
Hinge
Plastic
Plug Hole
Screw
Left Side
Door Swing
Invert Invert
Screw Hinge
ULIN_0106_A