Troubleshooting Guide - U-Line Wine Captain 1115WC Use And Care Manual

Troubleshooting Guide

DANGER
ELECTROCUTION HAZARD
Never attempt to repair or perform maintenance on
the unit until the main electrical power has been
disconnected.
Troubleshooting - What to check when problems occur:
PROBLEM
Unit does not operate and
electronic display is blank.
No interior light
Unit not cold enough. Check
temperatures (see OPERATION for
approximate temperatures).
Unit is too cold. Check temperatures
(see OPERATION for approximate
temperatures).
Electronic display is blank and
interior light is OFF with door OPEN.
Electronic display is blank and
interior light is ON with door OPEN.
Electronic display shows repeating,
randomly flashing symbols and
partial characters.
Electronic display shows:
0, 1 to 16, or 99
Electronic display shows one or
more of the following:
E1, E2, E4, E5, E6, E7, E8, E9, E10, P1.
22
POSSIBLE CAUSE
No electrical supply
Loose or burned out bulb
Control set too warm
High ambient temperature or
exposure to direct sunlight
Airflow to front grille blocked
Dirty condenser coils
Light staying on
Door gasket not sealing properly
Control set too cold
Unit is in blackout/Sabbath mode
(not Star K certified).
A display function has changed.
A factory control mode has been
inadvertently entered.
A factory control mode has been
inadvertently entered.
The unit is displaying an error code.
1115WC, 1175WC
REMEDY
Plug unit in or check circuit breaker.
Tighten or replace bulb (See MAINTENANCE; LIGHT
BULB REPLACEMENT).
Set control to a cooler setting (See OPERATION). Allow
24 hours for temperature to stabilize.
Reposition unit.
Airflow must not be obstructed to front grille (See
OPERATION).
Clean condenser (See MAINTENANCE; CONDENSER
CLEANING).
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT).
Adjust door (See MAINTENANCE; DOOR ALIGNMENT
CHECK AND ADJUSTMENT).
Set control to a warmer setting (See OPERATION). Allow
24 hours for temperature to stabilize.
Exit blackout/Sabbath mode (not Star K certified)
(See OPERATION).
Touch and hold the WARMER button and touch and
release the ON/OFF button three times, then release the
temperature button. The display should become visible.
Touch and hold the warmer temperature button and
touch and release the LIGHT button three times, then
release the temperature button to exit the factory
control mode. The set-point temperature should now
be displayed.
Repeatedly touch the WARMER button to advance any
number shown to 99 and touch and release the LIGHT
button. The set-point temperature should now be
displayed.
Record the error code(s) displayed and call for service.