Backshell Assembly - Garmin GMA 350 Installation Manual

Manufacturer
Crimping Tool
Military P/N M22520/2-01
Positronic 9507
ITT Cannon 995-0001-584
AMP 601966-1
Daniels AFM8
Astro 615717
1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
2. Extracting the #16, #18 and #20 contact requires that the expanded wire barrel be cut off from
the contact. It may also be necessary to push the pin out from the face of the connector when
using an extractor due to the absence of the wire. A new contact must be used when
reassembling the connector.
3. For applications using 16 AWG wire, contact Garmin for information regarding connector
crimp positioner tooling.
3.5

Backshell Assembly

The GMA 350/350H connector kit includes two Garmin backshell assemblies. Garmin's backshell
connectors give the installer the ability to quickly and easily terminate shield grounds at the backshell
housing using the Shield Block. To assemble the backshell connectors and grounding system, refer to
instructions provided in the Shield Block Installation Instructions (190-00313-09).
Page 3-2
Revision B
The document reference is online, please check the correspondence between the online documentation and the printed version.
Table 3-2. Recommended Crimp Tools
18-20 AWG
Hand
Positioner
N/A
9502-11
N/A
N/A
K774
N/A
NOTES
Insertion/ Positioner
Extraction Tool
(Note 2)
M81969/1-04 M22520/2-09
M81969/1-04 9502-3
N/A 995-0001-739
91067-1 601966-6
M81969/1-04 K42
M81969/1-04 615725
GMA 350/350H Installation Manual
22-28 AWG
Insertion/
Extraction
Tool
M81969/1-04
M81969/1-04
N/A
91067-1
M81969/1-04
M81969/1-04
190-01134-11