Bosch Professional GCM 12 GDL Original Instructions Manual page 33

Symbols and their meaning
CLASS 1 LASER PRODUCT
Keep hands away from the cutting area
while the power tool is running. Con-
tact with the saw blade can lead to injur-
ies.
Wear a dust mask.
Wear safety goggles.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Danger area! Keep hands, fingers and
arms away from this area.
Keep your fingers away from the mov-
ing parts of the glide arm. There is a risk
of fingers being crushed and severely in-
jured.
Take note of the dimensions of the saw
30
Ø
305 mm
Ø
mm
blade. The hole diameter must fit the tool
spindle without play. If it is necessary to
use reducers, ensure that the dimensions
of the reducer are suitable for the base
blade thickness and the saw blade hole
diameter, as well as the tool spindle dia-
meter. Wherever possible, use the redu-
cers provided with the saw blade.
The saw blade diameter must match the
information specified on the symbol.
When transporting the power tool, hold it
only at the locations indicated (recessed
handles) or by the transport handle.
Bosch Power Tools
Symbols and their meaning
Never carry the power tool using the
handle of the glide arm.
Switching on the laser
Clamping handle open:
Adjusting bevel angles is possible.
Clamping handle closed:
The set bevel angle of the glide arm is
locked.
Indicates the individual steps for adjust-
ing the bevel angle.
1. Loosen the clamping handle
2. Swivel the glide arm slightly to the left
3. Set the required bevel angle range us-
ing the rotary knob
Setting the bevel angle ranges using the
rotary knob:
Saw blade inclination to the left (45° to
0°)
Saw blade inclination to the right (0° to
45°)
Entire swivel range of the glide arm (-47°
to +47°)
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is intended as a stationary machine for mak-
ing straight cuts in wood with and against the grain. It is pos-
sible to cut mitre angles of -52° to +60° and bevel angles of
47° (to the left) to 47° (to the right).
The power tool is designed with sufficient capacity for saw-
ing hardwood and softwood as well as chipboard and fibre-
board.
English | 33
1 609 92A 5RR | (02.07.2020)