Grizzly Extreme Series G0514X Owner's Manual page 37

Aligning Table
To align the table so the miter slot is parallel
to the bandsaw blade:
1.
2.
3.
4.
Make sure the straightedge does not go
across a tooth.
5.
Figure 57
6.
7.
Figure 57.
Aligning Fence
To align the fence parallel with the miter slot:
1.
2.
3.
Note:
Figure 58.
4.
5.
Adjusting the fence parallel to the miter slot
does not guarantee straight cuts. The miter
slot may need to be adjusted parallel to the
side of the blade. Refer to the "Aligning
Table" instructions on this page.
Figure 58