Note: For a quick gauge, fold a dollar bill in half
twice (four thicknesses of a dollar bill is approxi-
mately 0.016") and place it between the support
bearing and the blade, as shown in Figure 53
Figure 53.
8.
Adjusting Lower Support Bearings
1.
2.
3.
Figure 54.
Figure 54
4.
must be re-aligned with the blade after the
lower guide block assembly is adjusted.
Refer to Page 35.
5.
6.
7.
Adjusting Blade
Guide Bearings
To adjust the upper and lower blade guides:
1.
2.
Figure 51
Note: The table
Figure 52
Figure 53