Advertisement
Step 3
Using a Phillips screw driver remove the two
screws on the plastic piece that holds the cables
to the battery tray, and remove the rubber plug
located at the front of the battery tray.
Step 5
Using a 3mm Allen wrench loosen the throttle
screw but do not remove and move throttle
away from the grip.
Step 7
Reverse the procedures
• Place the throttle in place and secure it back in place, clean the grip from any water or lubricant anr re-install
• Re-connect the throttle to control module
• Place batteries back inside the tray
• Re-attach deck with 4 screws
ATTENTION: Charge battery 12 hours before using
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Figure 3
Figure 5
Step 4
Follow the throttle wire and disconnect it from
control module, Locate the throttle cable cut the
Zip Tie and remove the cable wrap Note: save
the cable wrap for re-assembly. Gently pull the
throttle cable through the hole in the battery tray.
Step 6
Carefully wedge the flat head screwdriver under
the edge of the handlebar grip add a small
amount of lubricant or water and remove the
grip. Note: save the grip for re-assembly
Figure 4
Figure 6
2
Advertisement
