Advertisement
3
Snap together tube halves.
5
Place Tetra PowerStrip Assembly into correct position
and fasten assembly end cap to the sign with two
#6 (M3) screws.
Troubleshooting
Symptom
Row of modules does
• Check wire connections to power supply to ensure red stripe-to-red and white-to-black connections.
not light
• Check row-to-row polarity connections.
Sign does not light
• Check input and output voltage and check power supply input/output connections.
• Check polarity connections.
Individual modules
• Remove module and replace with another working module.
do not light
Modules are dim
• Ensure the overall length of the Tetra
• Ensure the length and gauge of the supply wire is equal to or below the recommended remote
RISK OF ELECTRIC SHOCK:
• Turn power OFF before inspection, installation
or removal.
• Properly ground Tetra Power Supply enclosure.
6180 Halle Drive • Valley View, Ohio 44125-4635 • USA
P: 216.606.6555 • F: 216.606.6599 • www.led.com • info@led.com
Lumination, LLC is a subsidiary of the General Electric Company. Tetra is a trademark of Lumination, LLC. The GE brand, logo, and ecomagination are trademarks of the General Electric Company.
© 2009 Lumination, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Solution
mounting distance.
Conforms to the following standards:
4
Feed wire through assembly end cap and slide into
assembly end cap.
Assembly
support
6
When mounting horizontally assembly supports MUST
BE used to support tubes approximately every 4 ft.
(1.22 m) by mounting assembly supports around tubes
and securing into support stringers with screws.
OPTIONAL: Install a tube connector for longer spans
up to 10 ft. (3.05 m) and push tube ends into connector.
LED system does not exceed the maximum load.
®
WARNING!
RISK OF FIRE:
• Follow all NEC and local codes.
• Use only UL approved wire for input/output
connections. Minimum size 18 AWG (0.82 mm
For customer service & technical support, contact:
1-888-MY-GE-LED
Support stringers
Tube
connector
)
2
(1.888.694.3533)
SIGN066-R060909
Advertisement
