Advertisement
Electrical Connections
NOTE: Refer to the power supply installation instructions for loading and remote mounting information.
Red stripe (+)
1
Connect modules using twist-on wire connectors
or in-line (IDC) connectors. Join white wires
together and red striped wires together.
NOTE: Additional supply wire may be necessary
to bridge electrical connections.
To LED System
Red (+)
3
Run a wire from the power supply to inside the
sign and connect to the first module on the strip.
OPTIONAL - Assemble and Install Tubes
Measure
Tetra PowerStrip tube
Assembly end caps
Sign
1
Measure and cut Tetra PowerStrip tube to the
appropriate length. Allow 1.75 inches (44 mm) for each
end cap. Leave a 0.25 inch (6 mm) gap between tube and
assembly end cap to allow for expansion or contraction.
Clean off any excess plastic debris.
White (-)
Black (-)
Power
Supply
2
Cap all exposed wires with appropriate end caps.
Red stripe (+)
To power supply
4
Connect the red stripe wire (+) of the LED system
to the red wire (+) of the power supply. Connect
the white wire (-) of the LED system to the black
wire (-) of the power supply.
Half of tube
2
Arrange modules approximately 1 module per
12 inches (305 mm). Snap modules into half of
the Tetra PowerStrip Tube.
White (-)
Red (+)
Black (-)
Advertisement
