Service Tools Required; Shutter; Range Finder Actuating Lever Link; Direct View Finder Cover - Kodak Medalist II How To Service

SERVICE TOOLS REQUIRED (See figure 23) . In following these instructions it is understood
that the right side referred to is the one to the
serviceman's right when the camera is held in the
picture-taking position.
Part No. Nomenclature
274 Crooked file
501-A Shutter retaining
collar wrench
501-B Focusingtube re-
taining collar
wrench
501-C Offset screw-
driver
501-0 Wrench
501-E Wrench
501-1 Bending tool
501-L Offset screw-
501-0
501-V
501-W
611
driver
Clamp
Ground glass and
spring clamp
Shutter protector
block
Special jeweler's
screwdriver
blade
SAFETY LATCH
BLADE ASSEMBLY
BLADE STUD NUT
Application
For filing the depth-of-focus
scale frame shoulder on the
direct view finder cover
For removing the shutter
from the camera
For removing the focusing
tube assembly from the cam-
era case
For adjusting the range find-
er prisms
For focusing the range finder
objective lenses
For adjusting the range find-
er prisms
For bending the trigger plate
or the trigger bell crank
For various screws
For removing the front lens
and mount from the shutter
For focusing
For use in protecting the shut-
terand lens when they are re-
moved from the camera
For removing and replacing
the terminal nut on the flash
terminal assembly
SHUTTER.
If
the repairs to be made involve only the shut-
ter, the shutter complete (figure 9) can be removed
from the camera without disassembling the camera.
Refer to page 5.
RANGE FINDER ACTUATING LEVER LINK.
The range finder actuating lever link (figure 1)
is located inside the camera. The end of the link
toward the back of the camera is slotted and slides
forward and back as the focusing tube assembly
(figure 9) is moved in and out.
NOTE: It is not necessary to remove
the range finder actuating lever link un-
less the range finder plate is to be re-
moved .
If the range finder plate must be removed, ex-
tend the focusing tube to the limit of travel and
remove the camera back.
Insert the blade of a jeweler's scr" e wdriver in
the key slot of the link, and pull the link back to
disengage it. Remove the link.
Retract the focusing tube to the closed pOSition.
LEVER LINK NUT
LINK
COUPLET BAR
STUD
ADJUSTING SCREW
BRACKET
Figure 1
1