Htek UC804 User Manual
Hide thumbs
Also See for UC804:
- User manual (158 pages) ,
- Quick reference (2 pages) ,
- Quick reference (2 pages)
Advertisement
Quick Links
Home
PBXware
SERVERware
TELCOware
SIPmon
SIPProt
Desktop & Mobile
BRM
UADs
Appliances
EOL
From Bicom Systems Wiki
Contents
1 Introduction - Htek Phones Configuration guide
2 Installation
2.1 Power Adapter
2.2 Power over Ethernet (PoE)
2.3 Factory Settings
3 Registering Phone
3.1 Manual Configuration
3.2 Auto Provisioning
Introduction - Htek Phones Configuration
guide
This User Guide is written as general guide on how to set up the Htek phone models: UC804,
UC806, UC840, UC842 and UC860.
Installation
This chapter describes how to install and connect the phone to the electrical power and data
network, as well as how to apply factory settings.
The following topics are covered:
- Power adapter
- Power over Ethernet (PoE)
- Factory Settings
Advertisement
Related Manuals for Htek UC804
Summary of Contents for Htek UC804
- Page 1 3.2 Auto Provisioning Introduction - Htek Phones Configuration guide This User Guide is written as general guide on how to set up the Htek phone models: UC804, UC806, UC840, UC842 and UC860. Installation This chapter describes how to install and connect the phone to the electrical power and data network, as well as how to apply factory settings.
-
Page 2: Registering Phone
Go to Factory Reset and press the Enter button. Registering Phone This chapter describes how to identify the Htek phone model, requirements that must be met, and how to register the phone using manual configuration or auto provisioning. The following topics are covered:... - Page 3 2. UAD settings Navigate to Settings:UAD. Make sure the Htek UAD is enabled. To check the UAD status, click on the edit icon corresponding to your Htek phone. Make sure Status is set to Active, Auto provisioning is set to No, and DHCP is set to Yes.
-
Page 4: Required Fields
Select the department to which the extension belongs. Select 'none' if not applicable. Click on the Save button. Registering Phone This chapter describes how to register a HTek phone using Hostname or IP Address. Hostname or IP Address Web Administration... - Page 5 Account 1. Login to phone web administration interface Open a new browser window and enter your phone IP address in order to access the phone's web administration interface login screen. For example: http://192.168.1.22 Login to the phone's web administration interface with your username and password. Please note, factory default login details are username: admin and password: admin.
- Page 6 2. UAD settings Navigate to Settings:UAD. Make sure the Htek UAD is enabled. To check the UAD status, click on the edit icon corresponding to your HTek phone. Make sure Status is set to Active, Auto provisioning is set to Yes, and DHCP is set to Yes.
- Page 7 Navigate to Extensions. Click on Add Extension. The standard options window will be shown below. Select the Htek phone model from the UAD select box. Select Location: Local or Remote. Local is for all extensions registered on the LAN and Remote is for all extensions registered from remote networks, WAN, Internet etc.
- Page 8 1. Login to the phone's web administration interface If there is no DHCP in your network, you can still auto provision your Htek phone. Please refer to your HTek phone model User Guide for instructions about setting the static IP address. After you configure your HTek phone to use a static IP address, continue with the following steps.
- Page 9 The auto provisioning process will start during the phone reboot process. The phone will pick up the appropriate configuration file from PBXware. If everything is done as above described, you should have successfully registered your phone to PBXware. Dial *123 to verify registration.
Need help?
Do you have a question about the UC804 and is the answer not in the manual?
Questions and answers