Netconnect Pack Contents; Step 1: Make Connections In Order Shown Below.; Step 3: Set Netconnect Mode To Master Using Drop Down Box.; Step 4: Enter Your Zone Name Into The Box (Kitchen, Dining Etc). - Systemline S7 NetConnect Quick Start Instructions

NetConnect pack contents

1 x NetConnect amp
2 x IMO speaker connectors
1 x Power supply
1 x Mains cable
1 x Quick start instructions
Description
This quick start guide is for a system using NetConnects only. If you are using an S7
NetServer all NetConnects should be set to slave mode.
Step 1
Make connections in order shown below.
During setup only one NetConnect should be connected to the network.
3) To power supply
1) To router, switch
or powerline
2) To speakers (left and right)
Step 2
Open a web browser and type //netconnect into the address bar to open quick setup.
Step 3
Set NetConnect mode to master using drop down box.
Only one NetConnect in your system should be set to master mode. Set the rest to slave
mode.
Step 4
Enter your Zone Name into the box (Kitchen, Dining etc).