Switching Input Signal; Controlling The Projector Through A Wired Lan Environment - BenQ LX710 User Manual

Switching input signal

The projector can be connected to multiple devices at the same time.
However, it can only display one full screen at a time. When starting
up, the projector automatically searches for the available signals.
Be sure the Advanced Menu - Settings > Auto Source Search
menu is On if you want the projector to automatically search for the
signals.
To select the source:
1. Press SOURCE. A source selection bar appears.
2. Press / until your desired signal is selected and press OK.
Once detected, the selected source information will appear at the corner of the screen for seconds.
If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector's native
resolution. Any other resolutions will be scaled by the projector depending upon the "aspect ratio" setting,
which may cause some image distortion or loss of picture clarity. See
Controlling the projector through a Wired LAN
environment
Wired LAN allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other
end to the RJ45 port.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or interruption.
2. Make sure the menu type is Advanced. See
Advanced OSD menu.
3. Go to Advanced - Network.
4. Highlight Wired LAN and then press OK. The Wired LAN page is displayed.
5. Press / to highlight DHCP and press
6. Press / to highlight Apply and press OK.
7. Go back to the Network page.
8. Press / to highlight AMX Device Discovery and press
AMX Device Discovery is On, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
Aspect Ratio on page
Using the menus on page 24
/ to select On.
/
Source
36.
for how to switch to the
to select On or Off. When
Operation 27