Connections - Panasonic AW-RP150G Operating Manual

Connections

Set the connection setting to "Serial" or "LAN" in the [CONNECT SETTING] menu.
CAM01 : AW-HR140
1
2
3
4
5
When connecting, observe the following points.
Serial connection
Connect the <SERIAL CONT 1 to 5> connector on this unit to the <RS-422> connector on the AW-HR140/AW-HE130
using a LAN cable (sold separately).
Use a straight cable (category 5e or higher; up to 1000 m (3280 ft) in length) for the LAN cable.
Do not connect a cable for PoE+/PoE++ power supply to the <SERIAL CONT 1 to 5> connector of this unit.
LAN connection
Connect the <IP CONT> connector on this unit to the <LINK / ACT> connector on the AW-HR140/AW-HE130 using a
LAN cable (sold separately).
Use a straight cable (category 5e or higher; up to 100 m (328.0 ft) in length) for the LAN cable (STP).
Configure the camera IP address and port number settings of the connection destinations in [SYSTEM] menu as well.
This unit can be powered using PoE+/PoE++. Use a switching hub with PoE+/PoE++ support.
For details on switching hubs and PoE+/PoE++ injectors that have been verified to support PoE+/PoE++, consult with your
dealer.
1 2
CONNECT
CAMERA
SETTING
6
TRACKING
CAM SEL CNNCT MD
1 Serial
CAM1 CAM2
Serial NON
CAM5 CAM6
NON NON
CAM9 CAM10
NON NON
CAM13 CAM14
NON NON
Connecting the Unit to AW-HR140/AW-HE130 Series Cameras
3 4
MANUAL AUTO
IP SET IP SET
DATA SAVE DATA LOAD
NO?
CAM3
NON
CAM7
NON
CAM11 CAM12
NON
CAM15 CAM16
NON
- 5 -
1 / 1
5
RP
IP SET
NO?
CAM4
NON
CAM8
1 11
NON
NON
NON