Mounting Your Camera - Akaso Brave 6 Plus User Manual

CR2032 BATTERY REPLACEMENT FOR REMOTE
1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of
the remote, allowing you to open it.
2. Remove another 4 screws on PCB board.
3. Lift the PCB board and slide out the battery, as shown in the picture.
Note: Do NOT rotate the PCB board to avoid reversing the camera and video button
functions.
4. Install the new battery, keeping the "+" pole facing up.
19
5. Install all 4 screws back onto the PCB board.
6. Install all 4 screws back into the cover.

MOUNTING YOUR CAMERA

Attach your camera to helmets, gear and equipment.
Open
Close
Note: Push and make sure that there is no gap between the waterproof strips of
the waterproof case.
Push
20