Light Cover Install For T-12Fg - True T-35 Installation Manual

True Food Service Equipment, Inc.
Light Cover Installation for T-12FG
REQUIRED TOOLS
• none
- IMPORTANT - IMPORTANT
Before installing lamp cover turn Before replacing light cover
turn cabinet on and wait until it
cabinet on and allow it to reach
reaches temperature.
temperature.
STEP 1
Locate rubber gasket behind lamp holder
mounted to evaporator housing. (See
Image 1).
STEP 2
Fit the bottom edge of the lamp cover
into the bottom groove of the rubber
gasket and rotate upwards while working
the edges into the rest of the rectangular
groove. (See Images 2-3).
(slide fingers underneath top edges of
rubber gasket and push rubber over the
top lip of the lamp shield)
STEP 3
Be sure lamp cover is seated properly in
rubber gasket.
NOTE
- IMPORTANT -
If cabinet is turned off and
Before replacing light cover
interior allowed to warm up lamp
turn cabinet on and wait until it cover may become loose and
reaches temperature. require reinstallation.
Follow directions above.
27
INSTALLATION / OPERATION INSTRUCTIONS
1
2
3
............ www.truemfg.com ............
Rubber Gasket
Lamp Holder
Lamp Cover
27