Table of Contents
Advertisement
Cabinet Operation
Startup
• The compressor is ready to operate when the unit is purchased.
All you need to do is plug in the cooler.
• Excessive tampering with the control could lead to service
difficulties. If replacing the temperature control is ever needed,
be sure to order the replacement from your TRUE dealer or
recommended service agent.
• Good air flow inside your TRUE unit is critical. Take care to
prevent product from pressing against the sides or back
wall and coming within 4" (101.6 mm) of the evaporator
housing. Refrigerated air off the evaporator coil must circulate
throughout the cabinet for even product temperatures.
NOTE: If the unit is disconnected or shut off, wait 5 minutes
before restarting.
– Before loading product, run your TRUE
RECOMMENDATION
unit empty for 24 hours to verify proper operation. Remember,
our factory warranty DOES NOT cover product loss!
For more information regarding a cabinet's general sequence of operation, including
TEC_TM_121 | REV. A | EN
TRADITIONAL REACH-INS
FOR MORE INFORMATION
basic temperature control adjustments, please visit our website:
www.truemfg.com/support/resource-library
Temperature Control & Light Switch Location
The light symbol
switch.
The electronic temperature control can act as a light switch.
To control the light, press the up arrow
Electronic Temperature Control with Digital Display
On the front of top panel.
Light Switch on Glass Door Models
Inside top ceiling.
Mechanical Temperature Control
Inside top ceiling.
Electronic Temperature Control with Digital Display
Behind the front bottom louvered grill.
03/3/2021
shows the approximate location of the light
.
ECO
°C
°F
ECO
°C
°F
truemfg.com
Page 11 of 22
Hide quick links:
Advertisement
Table of Contents
