Comfort Liner Removal And Reassembly; Venting System - ICON AIRFORM Series Owner's Instruction Manual

13

COMFORT LINER REMOVAL AND REASSEMBLY

How to remove your interior for cleaning or replacement:
1. With the helmet upside down and with the chin bar facing away from you release each cheekpad from the
helmet by pulling inward, freeing it from the snap and velcro system.
2. Turn the helmet until the chin bar faces toward you then pull each cheekpad towards you, removing the
cheekpads from the helmet. Note how the chin straps thread through the cheekpads and how the cheekpad
plate slips between the helmet shell and EPS liner for reassembly.
3. Remove your comfort liner by releasing it from the two snap sytem on the back of the helmet. Then
remove the crown comfort liner attachment point, taking note of how the crown plate attachment slips
into place between the shell and EPS liner.
4. Reverse these steps to reinstall the comfort liner and cheekpads.
SAFETY WARNING: The liner is essential to the intended performance of the helmet, it must be properly installed when using
the helmet.

VENTING SYSTEM

To activate the forehead vents, slide the
vents open by pushing them towards the
rear.
COOL AIR IN
14
14 14
WARM AIR OUT