Construction; Shell & Eps - ICON AIRFORM Series Owner's Instruction Manual

03

CONSTRUCTION

The ICON ® AIRFORM™ is engineered to the ICON WORLD STANDARD, which meets DOT FMVSS 218 (US), ECE 22.05
(EUROPE), & PSC (JAPAN) Helmet Safety Standards. Over 50 countries officially recognize these extensive head protection
standards. Refer to the diagram below to familiarize yourself with specific names and terms used on the AIRFORM™ helmet
before attempting to repair or replace parts on the helmet.
1 FOREHEAD VENTS
//
2 SHIELD RELEASE SYSTEM
//
3 EYEPORT GASKET
//
4 ICON OPTICS™ SHIELD
//
5 DROPSHIELD™
//
1
6 BREATH DEFLECTOR
//
//
7 MOUTH VENT
2
//
//
8 CHIN INTAKE VENTS
// 3
//
9 OUTER SHELL
//
4
10 REAR SPOILER //
//
11 EXHAUST VENTS
5
//
//
12 DUAL DENSITY EPS
//
6
//
13 DROPSHIELD™ SWITCH
//
14 SIDEPLATE
//
15 COMFORT LINER 7
// //
16 BASE GASKET
8
// //
MAKE NO MODIFICATIONS. To maintain the full effectiveness of this helmet, there should be no alteration to the structure of
this helmet or its component parts. Paints and adhesives may damage and render your helmet ineffective, without the damage
being visible to the user.
SHELL & EPS
The injection-molded polycarbonate PC-ABS
shell of the ICON ® AIRFORM™ helmet is
manufactured under some of the most stringent
quality control standards available on the market
today.
The ICON ® AIRFORM's dual-density
Expanded-Polystyrene liners are engineered
9
//
to offer impact absorption and
10
//
force dissipation.
11
//
Additionally, both liners are channeled with
12
// an extensive series of directional air ducts to
distribute airflow from the outer ventilation
13
//
system.
14 1 POLYCARBONATE SHELL
// //
2 EPS DENSITY 2
//
3 EPS DENSITY 1
//
15
//
16
//
1
//
2
//
3
//
04