Filters And Accessories; Water Filtration System - Whirlpool WRX735SDHV Use & Care Manual

FILTERS AND ACCESSORIES

To Steady the Refrigerator:
Open the freezer drawer. Using a 1/4" hex driver, turn both
I
brake feet clockwise the same amount until the brake feet are
snug against the oor. Check again. If not satis ed, continue
to adjust the brake feet by half turns of the screw until the
refrigerator does not roll forward when the drawer is opened.

Water Filtration System

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Install the Water Filter
1. Locate the accessory packet in the refrigerator and remove
the water lter.
2. Take the water lter out of its packaging and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
A
B
A. O-ring cover
B. O-rings
3. The water lter compartment is located in the right-hand side
of the refrigerator ceiling. Push up on the compartment door
to release the catch, then lower the door.
16
NOTE: Having someone push against the top of the refrigerator
takes some weight off the brake feet. This makes it easier to turn
the screws.
7. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place.
4. Align the arrow on the water lter label with the cutout notch
in the lter housing and insert the lter into the housing.
5. Turn the lter clockwise 90 degrees (1/4 turn), until it locks
into the housing.
NOTE: If the lter is not correctly locked into the housing, the
water dispenser will not operate. Water will not ow from the
dispenser.
6. While the compartment door is still open, lift the lter up into
the compartment. Then, close the lter compartment door
completely.
7. Flush the water system. See "Flushing the Water Filter" in the
"Water and Ice Dispensers" section.
IMPORTANT: If you do not ush the water system, you may
experience dripping and/or decreased ow from the water
dispenser.
The Water Filter Status Light
Press OPTIONS on the control panel to launch the Options menu.
Press OPTIONS, under Filter Status, again to display the
percentage of lter life remaining (from 99% to 0%). Press ICE/
WATER, under Back, to return to the Normal screen.
The water lter status lights will help you know when to change
your water lter.
ORDER FILTER (yellow) - it is almost time to change the water
I
lter. While you are dispensing water, "Order Filter" will blink
seven times and sound an alert tone three times.
REPLACE FILTER (red) - Replace the water lter. While you
I
are dispensing water, "Replace Filter" will blink seven times
and an alert tone will sound three times.