Kogan SMARTERHOME KASHSFP18BA User Manual page 4

• Do not run the power cable under carpeting. Do not cover the power cable with
rugs, runner or similar coverings. Arrange the power cable away from foot traffic
and where it will not be tripped over.
•
Do not wind the power cable around the unit.
•
Do not insert or allow foreign objects to enter any ventilation or opening on the
heater, as this may result in electric shock, fire or damage to the heater.
• Where possible, avoid the use of an extension cable as this may overheat and
cause a fire. However, if you have to use an extension cable, ensure it is suitable for
the purpose, has been tested for outdoor use and preferably has an RCD device
fitted or attached.
• Always ensure that the heater is plugged into a suitable socket.
•
Do not position directly above or below an electrical socket.
•
Always use on a dry, suitably strong, stable, flat and level surface.
•
Always unplug the unit and ensure that the unit has cooled completely before
moving, cleaning or storing.
•
This heater is intended for domestic use only and should not be used commercially
for contract purposes. Any alternative use, not recommended by Kogan.com, may
result in fire, electric shock or injury to persons.
•
Check exterior walls for areas of damage before installing the heater.
•
Check exterior walls for communication and electrical cables and pipelines. Should
any service lines be present in the immediate vicinity do not install your heater, find
an alternative location to install this product.
•
Do not remove any of the warning stickers or signs from the product.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
When the appliance is not in use and before cleaning, unplug the appliance from
the outlet firstly.
•
The heater must not be located immediately below a socket outlet.
•
Do not use this heater if it has been dropped.
•
Do not use if there are visible signs of damage to the heater.
•
Use this heater on a horizontal and stable surface, or attach it to the wall.
•
The heater is to be installed so that switches and other controls cannot be touched
by a person in the bath or shower.