GMI BT Assembly Instructions

TOOLS REQUIRED FOR ASSEMBLY

Socket set, Open end wrench set, Cordless drill with
3/8" socket bit (Magnetic recommended).

BEFORE ASSEMBLING THE WORKBENCH

Assembly of this bench will require 2 people.
Read through the assembly instructions to
familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.

HARDWARE

All assembly hardware is provided.
The legs have come pre-set at lab
height. If you would like to change
the height, remove 4 screws per leg
and adjust taller or shorter.
Attach the top support brace to the
back side of the legs. Note: Depending on
the width of the top an additional front brace
may be supplied.
Hand start the bolts into the threaded
inserts.
Use 1/4-20 x 1/2" bolts.
Hand start bolts to attach shelf
to the legs. Do Not fully
tighten.
Use 1/4-20 x 1/2" bolts.
Once all braces are attached, fully
tighten all bolts.
BT BENCH ASSEMBLY INSTRUCTIONS