GMI SR-400 Assembly Instructions

Table of Contents

Download this manual

BEFORE ASSEMBLING THE WORKBENCH

Read through the assembly instructions to familiarize

yourself with the order in which the parts are assembled.

We suggest that you clear & vacuum the area where

the bench is to be assembled.

**It is important that the bench is assembled in

the same sequence as instructed**

All assembly hardware is provided.

Attach the round uprights to the laminate surface.

Use 5/16 x 2" Bolts with a washer & lock washer. This will

thread into welded in nuts on the bottom of the uprights.

5/16" x 2"

Hex Head Bolt

Center the caster base on the bottom side

of the work surface. Attach with (24) #10 x 5/8"

SPAX Wood screws. Not every hole will need

to be used.

Lock Washer

Flat Washer

#10 x 5/8"

SPAX Wood Screw

SR-400 ASSEMBLY INSTRUCTIONS

Table of Contents

Do you have a question about the SR-400 and is the answer not in the manual?

Page 1 SR-400 ASSEMBLY INSTRUCTIONS BEFORE ASSEMBLING THE WORKBENCH Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled. We suggest that you clear & vacuum the area where the bench is to be assembled.
Page 2 Attach the casters to the caster rail. Thread the caster into the pre-installed nuts on the rail. Attach the cabinet to the base. First install the 4 threaded wood nut inserts into the surface of the base by screwing them in. Next lower the cabinet down and attach to the base using 1/4”...
Page 3 Next lower the LH worksurface down and attach to the cabinet using 1/4” x 3/4” flange head bolts. The bolts will insert through holes in the top of that cabinet and thread into the threaded wood inserts of the top. 1/4-20 x 3/4”...
Page 4 Attach the RH surface to the fiiller support and legs. Use 3 spax screws for the support and 5 Spax screws for each leg. #10 x 5/8” SPAX Wood Screw Attach the angled supports to the bottom side of the lectern surface.