GMI MG VAC Manual

TOOLS REQUIRED FOR ASSEMBLY

Cordless drill and 3/8 socket adapter, Wrench and 3/8
drive Socket set, Flat head screwdriver, hack saw for
pvc pipe cutting, Tape measure.

BEFORE ASSEMBLING THE WORKBENCH

Read through the assembly instructions to familiarize
yourself with the order in which the parts are
assembled.

HARDWARE

All assembly hardware is provided.
Bolt the casters to the bottom of the cabinet.
The cabinet will be heavy and may requre
assistance lifting. Note that two types of
casters are provided. Swivel and fixed. It is
recomended that two swivel casters be
mounted on the right and fixed on the left
side of the bench.
Place (1) 5/16 X 1-3/4" Hex Bolt through
(1) 5/16" Flatwasher and stick them through
one of the holes in the caster.
Stick the bolt and washer through one of
the holes through the bottom of the cabinet.
On the other end place (1) 5/16" Flatwasher onto the Hext
Bolt. Screw (1) 5/16" Locknut onto the Hex Bolt tighting the
caster to the cabinet bottom.
Repeat steps 1-2 for all four holes on the caster and then
repeat again for each caster that is to be connected to the
cabinet.
Locknut
Flatwasher
Flatwasher
Hex Bolt
Cabinet
5/16"
Flathead Washer
5/16 X 1-3/4"
Hex Bolt
MG VAC BENCH