Stihl FS 410 C-M Instruction Manual page 21

Brush knife 305-2 and 300-3
Aligning the cutting attachment
Cutting attachments with 2, 3 or 3 teeth
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
Mounting the cutting attachment
Fit the guard ring for mowing
N
applications.
4
3
2
b
a
Place the cutting attachment (1) in
N
position.
FS 410 C-M K, FS 460 C-M K, FS 490 C-M K
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
Fit the thrust washer (2) – convex
N
side must face up.
Fit the rider plate (3) (for mowing
N
applications).
Block the shaft.
N
Screw the mounting nut (4) on to the
N
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the cutting attachment
Block the shaft.
N
Unscrew the mounting nut
1
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Circular Saw Blades 200 and 225
Aligning the cutting attachment
Cutting edges of circular saw blades
must point clockwise.
Mounting the cutting attachment
Fit the guard ring for sawing
N
applications.
4
3
2
b
a
Place the cutting attachment (1) in
N
position.
English
1
19