Stihl FS 410 C-M Instruction Manual page 10

Hide thumbs Also See for FS 410 C-M:
Table of Contents

Advertisement

English
To reduce the risk of injury from
unintentional engine startup, always
shut off the engine and disconnect the
spark plug boot before performing any
repairs, maintenance or cleaning work. –
Exception: Carburetor and idle speed
adjustments.
Do not turn the engine over on the
starter with the spark plug boot or spark
plug removed since there is otherwise a
risk of fire from uncontained sparking.
To reduce the risk of fire, do not service
or store your machine near open flames.
Check the fuel filler cap for leaks at
regular intervals.
Use only a spark plug of the type
approved by STIHL and make sure it is
in good condition – see "Specifications".
Inspect the ignition lead (insulation in
good condition, secure connection).
Check the condition of the muffler.
To reduce the risk of fire and damage to
hearing, do not operate your machine if
the muffler is damaged or missing. –
Do not touch a hot muffler since burn
injury will result.
Vibration behavior is influenced by the
condition of the AV elements – check the
AV elements at regular intervals.
Symbols on Deflectors
An arrow on the deflector shows the
correct direction of rotation of the cutting
attachments.
Some of the following symbols are
applied to the outside of the deflector to
indicate the approved combination of
cutting attachment and deflector.
8
Deflector may be used
with mowing heads.
Deflector may be used
with grass cutting blades.
Deflector may be used
with brush knives.
Deflector may be used
with shredder blades.
Deflector must not be
used with mowing heads.
Deflector must not be
used with grass cutting
blades.
Deflector must not be
used with brush knives.
FS 410 C-M K, FS 460 C-M K, FS 490 C-M K
Deflector must not be
used with shredder
blades.
Deflector must not be
used with circular saw
blades.
Harness
The harness is included with the
machine or available as a special
accessory.
Use the harness.
N
With the engine running, attach the
N
machine to the harness.
Circular saw blades must always be
used in combination with a full harness
with a quick-release system.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs 490 c-mFs 460 c-m

Table of Contents