Advertisement
FIGURE 5
ASSEMBLY FOR HANDLE BAR
Step 1. Take off the bolts(H4), spring washers(H3) & washers(H2) from the axle tube(H1) before
assembly.
Step 2. Push axle tube(H1) into the middle of the tube welded at right angles to supporting tube(F).
Step 3. Push on handle bar(B2) & (B1) from each side.
** ATTENTION: The handles must be positioned after assembly so that the upper ends are bent
outwards.
Step 4. There are 8 setting to change the level of resistance. 1 is the lightest tension setting.
8 is the heaviest tension setting.
- 5 -
Advertisement
