Vox - Radioddity FS-T3 User Manual

VOX

When enabled it is not necessary to push the [PTT] button on the transceiver.
1. When VOX is on in your working channel:
Speak to the microphone directly, it will transmit automatically. The radio stops transmitting when
there is no sound, and waits for receiving.
11
2. When a headset with a microphone is used:
When VOX is on, you should VOX again for the radio to identify voice volume.
If the microphone is sensitive enough, the radio will start transmitting.
If the microphone is not sensitive enough, the radio cannot collect your voice. Please adjust your voice
volume to guarantee smooth communications.
3. VOX gain level:
When the sound level is higher than the level of VOX, VOX automatically transmits. The VOX gain
level can adjust from 1 to 5 levels.
4. When a signal is received, VOX will not transmit even if the sound level is higher than the set VOX
gain level.
Monitor
Turn on the radio, then press and hold the side key 1 to open the receiver and listen to whether there
is any voice on the current channel.
Scan
In standby mode, press and hold the [<] and [>] key for 2 second to start scanning, then press and hold
them to stop scanning.
12