techem Radio frequency smoke alarm 2 Operating Instructions Manual page 20

!
After the fault cause has been rectified, press the user key and remove yourself
from the RWM within a period of 10 seconds to allow the fault message to be
switched off on the RWM.
If rectification of the fault cause is not possible, please call the Hotline: 0800 2 00
1264(free of charge) as soon as possible.
For safety reasons, keep the doors to rooms with functional RWMs open until the
fault has been rectified.
The activation of environmental monitoring is signalled as follows:
Signal sound
2 short signal tones every 10 minutes
This is how the surroundings monitor signal tone is turned off for 3 days:
User key
Press the user key until a short
acknowledgement tone sounds
After deactivation for 3 days has been made three times, deactivation is then only possi-
ble for one day at a time.
Fault/ Damage
!
In case of a fault with, or damage to, the RWM, the device must be replaced as
soon as possible. Please immediately contact the Hotline: 0800 2 00 1264(free of
charge).
Do not attempt to repair defective RWMs. There are no exchangeable parts (e.g.
batteries). For safety reasons, keep the doors to rooms with functional RWMs
open until the defective RWM has been replaced.
Failure is signalled as follows:
Signal sound
3 short quiet signal tones every 5 minutes
This is how the surroundings monitor signal tone is turned off for 3 days:
User key
Press the user key until a short
acknowledgement tone sounds
After deactivation for 3 days has been made three times, deactivation is then only possi-
ble for one day at a time.
20
Red LED
Flashes twice every 30 seconds
Signal sound
Short acknowledgement tone
Red LED
Flashes once every 5 seconds
Signal sound
brief acknowledgement tone
Red LED
Flashes twice every 30 seconds
Red LED
Flashes once every 5 seconds