Off-Season Storage - Troy-Bilt Pro Line Operator's Manual

3. Reverse belt tension adjustments are done with the
reverse clutch cable adjuster located on the left side of the
machine near the engine. Use two 1⁄2" open-end wrenches
to loosen the two adjuster jam nuts a few turns. See Fig.
6-9.
Reverse Clutch
Cable Adjuster
Adjuster Jam Nuts
Figure 6-9
4. Move the cable adjuster away from the pulleys to increase
belt tension.
5. Tighten both jam nuts securely. Reinstall the belt cover.
6. Move the tiller to an open area and test the reverse
operation. Repeat this procedure if the machine does not
respond when the reverse clutch is engaged.

Off-Season Storage

When the tiller won't be used for extended periods, prepare it for
storage as follows:
1. Clean the tiller and engine. Do routine tiller lubrication and
check for loose parts and hardware.
2. Protect the engine and perform the recommended engine
maintenance by following the engine storage instructions
found in the separate Engine Operator's Manual.
NOTE: Be sure to protect the fuel lines, carburetor and fuel
tank from gum deposits by removing fuel or by treating
fuel with a fuel stabilizer (follow the engine manufacturer's
recommendations).
4. Charge the battery fully. The battery loses some of its
charge each day.
NOTE: Never store the battery without a full charge.
Recharge the battery before returning to service. When
storing the tiller for extended periods, disconnect the
battery cables. Removing the battery from the machine is
recommended.
5. Store the tiller in a clean, dry area.
6. Never store the tiller with fuel in the fuel tank in an
enclosed area where gas fumes could reach an open flame
or spark, or where ignition sources are present (space
heaters, hot water heaters, furnaces, etc.).
s 6 — M & a
ectiOn aintenance
1
djustMents