Advertisement
5. How to Switch the RAID Mode
A. Please clear the RAID setting and format your two used HDDs before start using your new
Rocpro T32.
B. Please BACKUP all of your data into a safe storage space before you set RAID mode on yourRocpro
T32 unit.
C. JBOD (Factory defaults): Two independent storage volumes with no data protection feature.
D. RAID-1:
One independent data storage with data protection feature.
Other features:
•RAID 1 data protection feature is to duplicate all your personal data into the second
HDD,and Rocpro T32 could still work in case if one of the HDDs becomes defective.
NOTE: There will not be any HDD/SDD redundancy or data protection if any of the two
HDD/SSD drives Fail.
•If you use two di erent HDD/SSD capacity drives, Rocpro T32 will only use
the maximummemory capacity up to the smaller drive.
** For example: if your two HDD/SSD Iinstalled are with 1TB & 2TB capacity each,
Rpcpro T32 maximum capacity will be up to 1TB.
E. RAID-0: One big independent storage with accelerated data transfer rate but with no dataprotection
or redundancy feature.
F. The Standard Procedure to Switch RAID Setting:
Step-1: Please rst connect Rocpro T32 to your Mac or PC.
Step-2: Please set RAID Dip Switch to the position you choose.
Step-3: Please use the Key to press the hidden RESET key at the back-plate, hold and
Step-4: Please turn o your Rocpro T32, and turn it on again. You now have reset
WARNING: Before you delete or switch your original RAID setting,
please always backup your data before changing your RAID settings.
Your original data will be lost after you change the RAID settings.
ROCPRO™ T32 / User Manual
wait for the end of Blue-Purple LED blinking till a stable Blue light.
Rocpro T32 with a new RAID mode successfully.
page 6 - 8
Advertisement
