Raid System Installation; Installing Disk Drives; Connecting Cable To Accustor Pr3600 - Rocstor accustor PR3600 User Manual

3.2 RAID System installation

Follow the instructions in this section to hook up all your hardware components of the
Accustor PR3600 system. Do not turn the power on until all components are properly installed.
3.2.1
Follow the steps below to install your HDDs.
1. Place the HDD with connector align with the edge of the disk tray.
2. Secure HDD with screws as below figures.
3. Slide the disk tray into the disk bays of the chassis.
Four screws for 3.5"
4. Push the tray inward until the tray firmly connects and you hear the tray click into
place.
5. Repeat for all drives to be installed into the Accustor PR3600.
Note
The hard drives in a RAID system should match in size and speed. All
drives in an array should be identical models with the same firmware
version.
3.2.2
Supports Thunderbolt cables that are certified by Intel, refer to below picture on where to
connect Thunderbolt cable.
User Guide

Installing Disk Drives

Three screws for 2.5"

Connecting cable to Accustor PR3600

Insert tray into Accustor PR3600
4. How to Use